ねじりが棒線材のせん断加工のだれ高さに与える影響

DOI Web Site 被引用文献4件 参考文献15件

書誌事項

タイトル別名
  • Effect of Torsion on Droop Height in Shearing of Bars and Wires
  • ネジリ ガ ボウ センザイ ノ センダンカコウ ノ ダレ タカサ ニ アタエル エイキョウ : ボウ センザイ ノ ネジリ フカ セン ダンカコウ(ダイ1ポウ)
  • — Shearing with Torsion of Bars and Wires I —
  • — 棒線材のねじり付加せん断加工　第1報 —

この論文をさがす

抄録

Shearing is a commonly used method of cutting materials for former from bars or wires. However, the cut face shape of a material after shearing is worse than that obtained with machine, saw, or laser cutting because droop and burr are formed at the edge of the cut face. It is necessary to alter the cut face shape after shearing for use in former. The cut face of a ductile material fractured by torsion is perpendicular to the longitudinal direction of bars or wires without droop or burr. In this research, we developed a new shearing method in which shearing is combined with twisting to achieve a short cutting time with a length high accuracy and a cut surface without droop or burr. A prototype machine for shearing a material with torsion was developed. Low-carbon steel bars (diameter: 1.96 mm) were used for the experiment. The specimens were annealed at 1123 K for 2 h. The specimens were sheared after being twisted at several torsion angles. As a result, the height of droop and burr decreased in the case of shearing with torsion, as compared with that in the case of only shearing.

収録刊行物

  • 塑性と加工

    塑性と加工 53 (615), 341-345, 2012

    一般社団法人 日本塑性加工学会

被引用文献 (4)*注記

もっと見る

参考文献 (15)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ