Influence of Cu and Mg Addition on Mechanical Properties and Thermal Fatigue Life of Al-Si-Mg Cast Alloys for Cylinder Head
-
- Moizumi Ken
- ISUZU MOTORS LIMITED
-
- Tezuka Hiroyasu
- Tokyo Institute of Technology
-
- Sato Tatsuo
- Tokyo Institute of Technology
Bibliographic Information
- Other Title
-
- シリンダヘッド用 Al-Si-Mg系鋳造合金の機械的性質と熱疲労寿命に及ぼす Cu,Mg添加の影響
- シリンダヘッドヨウ Al Si Mgケイ チュウゾウ ゴウキン ノ キカイテキ セイシツ ト ネツ ヒロウ ジュミョウ ニ オヨボス Cu Mg テンカ ノ エイキョウ
Search this article
Abstract
As an attempt to optimize materials for diesel engine cylinder heads, the chemical composition and heat treatment procedure of Al-Si-Mg alloy were studied. The relation between additional elements and mechanical properties (tensile strength and elongation) was investigated on AC4C aluminum alloys containing additional Cu or Mg, and the optimum chemical composition was determined. In composition ranges within 0.6 mass%Mg or 1.0 mass%Cu, it was found that Cu or Mg addition increased tensile strength without deterioration of elongation, and also increased high cycle fatigue strength. However, thermal fatigue tests indicated that Cu addition affected thermal fatigue life. Especially thermal fatigue life markedly decreased with increasing plastic strain. In addition, excessive aging of Cu addition alloys resulted in increased thermal fatigue life. This is because the thermal fatigue life corresponding to plastic strain increases in excessively aged alloy.
Journal
-
- Journal of Japan Foundry Engineering Society
-
Journal of Japan Foundry Engineering Society 75 (6), 397-402, 2003
Japan Foundry Engineering Society
- Tweet
Details 詳細情報について
-
- CRID
- 1390001206506041728
-
- NII Article ID
- 130004556474
- 10013907567
-
- NII Book ID
- AN10514770
-
- COI
- 1:CAS:528:DC%2BD3sXmsFGnsLw%3D
-
- ISSN
- 21855374
- 13420429
-
- NDL BIB ID
- 6615747
-
- Text Lang
- en
-
- Data Source
-
- JaLC
- NDL
- CiNii Articles
-
- Abstract License Flag
- Disallowed