Continuous Casting of Shape Memory Cu-Al-Ni Alloy Wires by OCC Process
-
- Motoyasu Genjiro
- 千葉工業大学金属工学科 工博
-
- Kaneko Masaki
- 千葉工業大学大学院〔現 (株)オプトニクス精密〕
-
- Fujiwara Yasuyuki
- 千葉工業大学金属工学科
-
- Soda Hiroshi
- トロント大学 金属・材料工学科 工博
Bibliographic Information
- Other Title
-
- OCCプロセスによる Cu-Al-Ni 形状記憶合金線の連続鋳造
- OCCプロセスによるCu-AI-Ni形状記憶合金線の連続鋳造
- OCC プロセスニヨルCu-AI-Ni ケイジョウ キオク ゴウキンセン ノ
Search this article
Abstract
The possibility of applying the Ohno continuous casting (OCC) process for fabricating Cu-based shape memory alloy wires was examined using Cu-14.1 mass % Al-4.2 mass % Ni alloy. Most of the cast wires, 2mm in diameter, were found to have unidirectional structures with a matrix phase of β1 in which fine γ2 particles were dispersed. It was found that at a lower casting speed range (0.8∼1.5 mm/ s), the cast wires showed shape memory effects arising from stress-induced martensitic transformations. At higher casting speeds (1.8∼2.5 mm/s), the cast wires produced exhibited super elasticity at room temperature. In addition, the fatigue failure of the cast wires (casting speed : 2.5 mm/s) occurred after 6500 of cycles of bending.
Journal
-
- Journal of Japan Foundry Engineering Society
-
Journal of Japan Foundry Engineering Society 70 (9), 635-640, 1998
Japan Foundry Engineering Society
- Tweet
Details 詳細情報について
-
- CRID
- 1390001206506190848
-
- NII Article ID
- 10002554162
-
- NII Book ID
- AN10514770
-
- ISSN
- 21855374
- 13420429
-
- NDL BIB ID
- 4564963
-
- Text Lang
- en
-
- Data Source
-
- JaLC
- NDL
- CiNii Articles
-
- Abstract License Flag
- Disallowed