Studies on the technology of direct causticizing process by ferric oxide. Part 1. Studies on soda quinone pulping. 3. Soda quinone pulping conditions.

DOI Web Site

Bibliographic Information

Other Title
  • 酸化鉄法直接か性化技術　Ｉ　　ソーダキノン蒸解　３　　ソーダキノン蒸解条件の影響
  • サンカ テツ ホウ チョクセツ カセイカ ギジュツ ニ カンスル ケンキュウ
  • 3-Soda Quinone Pulping Conditions
  • 第3報-ソーダキノン蒸解条件の影響

Search this article

Abstract

Laboratory studies for direct caustcizing process by ferric oxide in soda quinone pulping conditions were carried out in comparison with kraft pulping. DDA (1, 4-dihydro-9, 10-dihydroxy anthracene sodium salt) was used as quinone with addition of 0.1% as AQ by weight on o. d. wood. In the case of soda quinone pulping of Douglas fir, low temp.-long time pulping at the same H-factor and short time-high alkali pulping at the same τ-factor gave the same Kappa number of pulp, but low temp.-high alkali pulping at the same τ-factor gave a slihgtly high Kappa number pulp. By different pulping conditions, pulp yield and pulp properties were slightly different each other. There are not negligible differences in pulp yield and pulp properties at the same Kappa number by three different Douglas fir chip lot from different pulp mills in Japan. Almost same results with previous reports were obtained by the reappearance tests of soda quinone pulping of Douglas fir and eucalyptus at low Kappa number, and tear strength of soda quinone pulp of Douglas fir was ca. 10% lower than KP by statistical analysis.

Journal

  • JAPAN TAPPI JOURNAL

    JAPAN TAPPI JOURNAL 40 (9), 870-876, 1986

    JAPAN TECHNICAL ASSOCIATION OF THE PULP AND PAPER INDUSTRY

Keywords

Details 詳細情報について

Report a problem

Back to top