ゴムOリングのブリスタ破壊の可視化評価

  • 古賀 敦
    NOK株式会社 材料技術部
  • 山部 匡央
    NOK株式会社 材料技術部
  • 佐藤 博幸
    NOK株式会社 材料技術部
  • 内田 賢一
    NOK株式会社 材料技術部
  • 中山 純一
    NOK株式会社 材料技術部
  • 山辺 純一郎
    九州大学水素エネルギー国際研究センター (独)産業技術総合研究所水素材料先端科学研究センター
  • 西村 伸
    九州大学大学院工学研究院機械工学部門 (独)産業技術総合研究所水素材料先端科学研究センター

書誌事項

タイトル別名
  • A Visualizing Study of Blister Fracture in Rubber O-rings
  • ゴム Oリング ノ ブリスタ ハカイ ノ カシカ ヒョウカ

この論文をさがす

抄録

In order to establish a hydrogen energy system, the reliability of sealing rubber for high-pressure hydrogen has been required. The rubber O-ring for hydrogen energy system is used with pressurized-decompress cycle of high-pressure hydrogen. It causes internal cracks referred as blister fracture. Degradation of seal performance originated from blister fracture is one of the important issues to improve the reliability. This study focused on the blister initiation behavior and the effect of materials, gas species and decompression rate on blister fracture in terms of visualizing O-ring behavior under high-pressure gas. For the visualizing evaluation, a transparent ethylene-propylene rubber (EPDM) and vinyl-methyl silicone rubber (VMQ) O-rings were molded, and a special viewable high-pressure vessel with a glass viewport was developed. The O-ring specimens were exposed to high-pressure hydrogen, helium, and nitrogen at 10 MPa until gas solubility content in O-ring was saturated; afterwards, these gases were decompressed with some rate. It was obviously visualized that the blister fracture did not occur in VMQ O-ring but occurred in EPDM. The blister fracture of the EPDM O-ring in nitrogen was the most serious in the tested gases. These blister behaviors are considered to be related to gas diffusivity of hydrogen, helium and nitrogen.

収録刊行物

  • 日本ゴム協会誌

    日本ゴム協会誌 85 (5), 162-167, 2012

    一般社団法人 日本ゴム協会

被引用文献 (2)*注記

もっと見る

参考文献 (18)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ