混合潤滑状態にある転がり-すべり接触面の摩擦係数推定式（第2報）

DOI Web Site 参考文献23件

書誌事項

タイトル別名
  • Estimation Formula of Friction Coefficient of Rolling-Sliding Contact Surface under Mixed Lubrication Condition (Part 2)
  • 混合潤滑状態にある転がり : すべり接触面の摩擦係数推定式(第2報)摩擦係数に及ぼす表面粗さ形状の影響
  • コンゴウ ジュンカツ ジョウタイ ニ アル コロガリ : スベリ セッショクメン ノ マサツ ケイスウ スイテイシキ(ダイ2ホウ)マサツ ケイスウ ニ オヨボス ヒョウメン アラサ ケイジョウ ノ エイキョウ
  • ─摩擦係数に及ぼす表面粗さ形状の影響─
  • ─Effect of Surface Roughness Profile on Friction Coefficient─

この論文をさがす

抄録

<p>To decrease the power loss of power transmission gears, it is necessary to estimate friction coefficient at tooth meshing surface. And to prevent the failures like scuffing and pitting on tooth surface, it is necessary to decrease the flash temperature and tangential force that are proportional to friction coefficient. But there was no formula with high accuracy for estimation of friction coefficient under mixed lubrication condition considered a ratio of surface roughness and oil film thickness. In this paper, empirical validation of the new estimation formula of friction coefficient was carried out. In the contact zone under mixed lubrication, a combination of fluid friction and boundary friction exists. The new function of load ratio expressed as a simple function of the ratio of surface roughness and elastohydrodynamic lubrication minimum oil film thickness was verified. To evaluate the formula, two disc tests were conducted. The estimated values agreed well with the experimental results. The friction coefficient can be estimated by using the new function of load ratio constructed by the maximum height surface roughness. And there is no effect of average surface roughness on the friction coefficient. And there is further fact that the maximum height of grooved surface by turning can be treated as the surface with roughness height from contact surface.</p>

収録刊行物

  • トライボロジスト

    トライボロジスト 58 (9), 676-684, 2013-09-15

    一般社団法人 日本トライボロジー学会

参考文献 (23)*注記

もっと見る

関連プロジェクト

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ