電子ビーム積層造形法により作製したTiAl 合金の熱間等方圧加圧法による高温疲労特性改善

  • 趙 研
    大阪大学大学院工学研究科マテリアル生産科学専攻
  • 安田 弘行
    大阪大学大学院工学研究科マテリアル生産科学専攻
  • 當代 光陽
    新居浜工業高等専門学校環境材料工学科
  • 上田 実
    金属技研株式会社
  • 竹山 雅夫
    東京工業大学物質理工学院 材料系
  • 中野 貴由
    大阪大学大学院工学研究科マテリアル生産科学専攻

書誌事項

タイトル別名
  • Improvement of High Temperature Fatigue Properties of TiAl Alloys Fabricated by Electron Beam Melting Through Hot Isostatic Pressing Process
  • デンシ ビーム セキソウ ゾウケイホウ ニ ヨリ サクセイ シタ TiAl ゴウキン ノ ネツカン トウ カタアツ カアツホウ ニ ヨル コウオン ヒロウ トクセイ カイゼン

この論文をさがす

抄録

TiAl rods were fabricated by electron beam melting followed by hot isostatic pressing(HIP)and the microstructure and high temperature fatigue properties were examined focusing on HIP temperature. Unique layered microstructure consisting of a duplexlike region and equiaxed γ grain layers(γ bands)is formed in as built samples. The layered microstructure is completely replaced by fully lamellar microstructure by HIP treatment at 1633 K, while it can be maintained at 1523 K or 1463 K. In addition, the volume fraction of the α2 phase in the γ bands can be controlled by selecting HIP temperature, according to the phase diagram of the alloy. The rods subjected to the HIP treatment at 1523 K or 1463 K exhibit higher fatigue strength at 1023 K than as built rods and HIPtreated cast alloys. It was found that the high fatigue strength of the rods at low cycle fatigue life region is caused by inhibition of the crack initiation due to the high ductility. On the other hand, the strength at high cycle fatigue life region is possible to be improved by the suppression of pores and precipitation of the α2 phase in the γ bands though the HIP treatment under appropriate conditions.

収録刊行物

  • Journal of Smart Processing

    Journal of Smart Processing 9 (4), 180-184, 2020-07-10

    一般社団法人 スマートプロセス学会 (旧高温学会)

被引用文献 (2)*注記

もっと見る

参考文献 (19)*注記

もっと見る

関連プロジェクト

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ