High Strain and Microstructure Transforming in Laser Peening Ti-6Al-4V
-
- SHIKUN Zou
- College of Mechanical Science and Engineering, Huazhong University of Science and Technology Beijing Aeronautical Manufacturing Technology Research Institute
-
- SHUILI Gong
- College of Mechanical Science and Engineering, Huazhong University of Science and Technology Beijing Aeronautical Manufacturing Technology Research Institute
-
- ENMING Guo
- College of Mechanical Science and Engineering, Huazhong University of Science and Technology
Search this article
Abstract
In order to analyze high strain produced by laser peening during tens of ns, which can’t be performed in so short process, the surface profi le of after laser peening with square spots was compared with that with circle spots, steep sidestep showed high stain and deformation produced in laser peening with square spot. The microstructure transforming in laser peening titanium alloy Ti-6Al-4V in the center of shocked zone and at the edge of square spot was researched in this paper. The results showed that nanometers size crystals were formed at the edge of square spots because of the shearing strain produced during laser peening of titanium alloy Ti-6Al-4V.
Journal
-
- The Review of Laser Engineering
-
The Review of Laser Engineering 42 (6), 486-, 2014
The Laser Society of Japan
- Tweet
Details 詳細情報について
-
- CRID
- 1390004222614276992
-
- NII Article ID
- 130007897588
- 40020137554
-
- NII Book ID
- AN00255326
-
- ISSN
- 13496603
- 03870200
-
- NDL BIB ID
- 025612328
-
- Text Lang
- en
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed