POMとクロムモリブデン鋼の往復すべり摩擦における シリコーンオイルの潤滑特性

DOI

書誌事項

タイトル別名
  • Lubrication Properties of Silicone Oil between POM and Chromium Molybdenum Steel under Reciprocating Sliding

抄録

<p>Ball joints are automotive products that perform reciprocating sliding motion of metal and resin components with grease lubrication between them. Understanding the effects of temperature on the characteristics of product components and their elements is necessary to design ball joints that are applicable to a wide range of temperatures. The viscosity of the grease base oil has the most effects of temperature. To investigate the applicability of PDMS base oil grease, which has a smaller viscosity dependence than the current PAO base oil grease, the lubrication properties of PDMS oil and PAO oil between resin (POM) and metal (chromium molybdenum steel) were studied by reciprocating sliding friction test. Seven PDMS oils with a wide range of viscosities were used in the experiments, assuming that the viscosity of the oil changes over the temperature range required for practical use. Lower viscosity PDMS showed an increase of contact areas in mixed lubrication mode but effect on the friction coefficient was small while higher viscosity PDMS caused lubrication starvation in the latter half of the test. These results indicate that there is an upper limit of viscosity where lubrication can be maintained.</p>

収録刊行物

  • 設計工学

    設計工学 59 (3), 119-132, 2024

    公益社団法人 日本設計工学会

詳細情報 詳細情報について

  • CRID
    1390017887629675136
  • DOI
    10.14953/jjsde.2023.2995
  • ISSN
    21889023
    09192948
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ