DIC Analysis of Large-deflection deformation during Sintering of MIM Compacts

DOI Web Site 参考文献12件

説明

<p>Powder molded compacts, characterized by low powder filling rates such as Metal Injection Molding (MIM), often exhibit problems with deformation during sintering due to their large shrinkage and low strength. In this study, the Digital Image Correlation method (DIC) was used for in-situ observation of sintering in Ni powder compacts fabricated by MIM to investigate their large-deflection deformation behavior. As a result, it was revealed that there is a time point when the deviatoric vertical strain in the longitudinal direction becomes tensile across the entire base of the molded compacts. This strain distribution was not symmetrical distribution of tensile and compressive strains, as is typically observed in the small deflection deformation of an elastic body. Additionally, a finite element analysis was performed using a plastic deformation model for porous materials, and it was confirmed that similar results were obtained.</p>

収録刊行物

  • 粉体および粉末冶金

    粉体および粉末冶金 72 (Supplement), S651-S658, 2025-03-15

    一般社団法人 粉体粉末冶金協会

参考文献 (12)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ