アパタイト鉱物中のサマリウムの溶媒抽出-誘導結合プラズマ発光分析法による定量

DOI NDLデジタルコレクション Web Site Web Site 被引用文献1件

書誌事項

タイトル別名
  • Determination of samarium in apatite minerals by solvent extraction-inductively coupled plasma atomic emission spectrometry.
  • アパタイト鉱物中のサマリウムの溶媒抽出‐誘導結合プラズマ発光分析法による定量
  • アパタイト コウブツチュウ ノ サマリウム ノ ヨウバイ チュウシュツ ユウド

この論文をさがす

説明

Inductively coupled plasma atomic emission spectrometry (ICP-AES) was applied to the determination of samarium in calcium apatite minerals. The detection limits(S/N=3) of samarium in distilled water and in cyclooctane were 0.66μg/ml and 0.30 μg/ml, respectively. The effect of coexisting elements other than the matrix components on the samarium emission intensity was scarcely observed at 443.43 nm. However, a large amount of calcium phosphate showed high spectral interference and signal suppression. Hence, the separation of samarium from the matrix by solvent extraction was studied with alkanes and cycloalkanes as solvents. Cyclohexane, a more commonly used solvent, was useless in this case, because it extinguished the ICP flame soon after the introduction. The ICP operating conditions with the organic solvents were 2.0 kW R.F. power, 0.481/min carrier gas, 201/min coolant gas, and 1.21/min plasma gas. The experimental results showed that the stability of the ICP flame is higher for higher hydrocarbons. Thus, cyclooctane was used as an extraction solvent in the present work. The apatite minerals(1 g) were dissolved in hot nitric acid, evaporated to dryness, and dissolved in perchloric acid (1011 M, 100 ml). Samarium was then extracted into cyclooctane containing 0.1 M-HDEHP, and determined by ICP-AES. The samarium content in the apatite minerals was found to be (0.261.81)×10-3 %.

収録刊行物

  • 分析化学

    分析化学 33 (9), 465-471, 1984

    公益社団法人 日本分析化学会

被引用文献 (1)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ