連続多層溶接におけるルート割れ防止のための予熱温度選定手法

DOI NDLデジタルコレクション Web Site

書誌事項

タイトル別名
  • Preheat Temperature for Preventing Root Cracking in Continuous Multi-Pass Welding
  • レンゾク タソウ ヨウセツ ニ オケル ルート ワレ ボウシ ノ タメ ノ ヨ

この論文をさがす

抄録

There are instances where employing the preheat temperature for preventing root cracking as determined from single-pass welding cracking test results for the continuous multi-pass welding errs on the side of safety.<BR>The authors devised a preheat temperature selection procedure and successfully developed a handy formula to prevent the root cracking in continuous multi-pass welding.<BR>Parameters employed in the preheat temperature selection procedure and the formula thereby obtained are summarized as follows : <BR>(1) The susceptibility to weld root cracking in continuous multi-pass welding is less than in single-pass welding, mainly because of decrease in hydrogen at the root due to post weld heating effect. This effect is expressed by thermal factor (ΣDδt) which is determined by thermal cycle.<BR>(2) Nearly the same critical thermal factor [(ΣDδt) cr] for root cracking applies to both continuous multi-pass welding and in single-pass welding. (ΣDδt) cr is given by the following weldment cracking parameter (Cw) <BR>(ΣDδt) cr=7.94×10-4Cw-0.123<BR>Cw=0.32HVmax.+30.5 log H0+F1 × σw<BR>where, F1 × σw is a local stress parameter for root cracking. (3) Critical cooling time to 100°C [(t100) cr] for root cracking is given as : <BR>(t100) cr=exp [1.22 {ln1/α (7.94×10-4Cw-0.123) +9.79}] <BR>α= 1 : Single-pass welding<BR>2 : Continuous multi-pass welding

収録刊行物

詳細情報 詳細情報について

問題の指摘

ページトップへ