岩石の異方性多孔質弾性パラメータの計測および評価手法に関する検討

  • 徳永 朋祥
    東京大学大学院工学系研究科地球システム工学専攻

書誌事項

タイトル別名
  • Measurements of Complete Set of Anisotropic Poroelastic Parameters for Berea Sandstone and Evaluation of Experimental Data Sets.
  • ガンセキ ノ イホウセイ タコウシツ ダンセイ パラメータ ノ ケイソク オヨビ ヒョウカ シュホウ ニ カンスル ケントウ

この論文をさがす

抄録

A complete set of anisotropic poroelastic parameters for Berea sandstone at low TERZAGHI effective stress (confining stress minus pore fluid pressure) was obtained for a series of drained, undrained and unjacketed tests using a triaxial vessel. Thirty-six stress-strain and stress-pore pressure slopes were obtained from hydrostatic and uniaxial experiments on three samples whose orientations were parallel, perpendicular, and forty-five degrees to the bedding plane. Stressstrain slopes during hydrostatic experiments indicated that the sandstone's poroelastic behavior was transversely isotropic. A non-linear least-square fitting technique was applied to obtain the complete set of poroelastic parameters. Results show that the sandstone is poroelastically anisotropic at low TERZAGHI effective stress conditions but it is reasonable to assume micro-isotropy. Volumetric compliances obtained from this result with that from previous measurements, which assumed that the sandstone was isotropic, were consistent between each other.<BR>This technique gives us internal consistency checks and a measure of the reliability of the values, and it yields a more reliable set of poroelastic constants.

収録刊行物

  • 応用地質

    応用地質 41 (2), 70-76, 2000

    一般社団法人 日本応用地質学会

被引用文献 (3)*注記

もっと見る

参考文献 (20)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ