Iodine Mass Transfer from Xenon-Iodine Mixed Gas Bubble to Liquid Sodium Pool, (II). Development of Analytical Model.

DOI DOI Web Site 被引用文献1件 参考文献29件
  • MIYAHARA Shinya
    Oarai Engineering Center, Power Reactor and Nuclear Fuel Development Corporation Graduate School of Engineering, IbarakiUniversity.
  • SAGAWA Norihiko
    Department of Mechanical Engineering, Faculty of Engineering, Ibaraki University Collaborative researcher of Power Reactor and Nuclear FuelDevelopment Corporation

書誌事項

タイトル別名
  • Development of Analytical Model

この論文をさがす

説明

Iodine mass transfer in a xenon-iodine mixed gas bubble rising through a liquid sodium pool is analyzed on the basis of a diffusion model applied to the first short stage just after the bubble generation and a convection model applied to the successive stage. In the diffusion model, production of sodium iodide aerosols and generation of the heat caused by the chemical reaction of iodine vapor and sodium vapor are taken into account in addition to the diffusion of vapor and aerosols and the heat conduction in a static spherical bubble. The diffusion of aerosols is composed of Brownian motion, thermophoresis and diffusiophoresis. In the convection model, the analysis is made for aerosol settling caused by inertial deposition, sedimentation and Brownian motion in an internal flow induced by a spherical cap bubble rising. <BR>Increase in the initial iodine concentration in the bubble is shown to enlarge the temperature difference across a region between the reaction front and the bubble surface and to enhance a contribution of thermophoresis to the aerosol diffusion through the region. The decontamination factor obtained from the calculation describes well a rapid increase at the first stage and a slow increase in the successive period, which are seen in measured decontamination factors, and suggests the breakup of the original bubble during rising through the pool.

収録刊行物

被引用文献 (1)*注記

もっと見る

参考文献 (29)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ