光沢めっき法による複眼レンズ金型製造の検討

DOI Web Site 被引用文献1件 参考文献11件

書誌事項

タイトル別名
  • Production of Compound Eyes Metal Molds by Bright Plating Method.
  • コウタクメッキ ホウ ニ ヨル フクガン レンズ カナガタ セイゾウ ノ ケン

この論文をさがす

抄録

Production of compound eyes lens metal molds are cutting method etc. But, the report of plating method investigated.<br>Therefor, production of compound eyes lens metal molds by bright plating method were investigated.<br>We was studied production of compound eyes lens metal mold by bright plating method.<br>We made a hemisphere metal mold with a surface roughness (Rmax) of 40∼120nm and the radius curvature of 0.44∼1.4mm when we controlled a nickel sulfate concentration and a integrating current and a hole diameter of photo-resist pattern and a electro-conductive film.<br>Rmax, was lowest with a nickel sulfate concentration of 20∼30%, and decreased with increasing an anode size, e.g. maximum Rmax, was 40nm with a nickel sulfate concentration of 20% and an anode size of 0.25dm2.<br>Curvature radius decreased with increasing a nickel sulfate concentration, and decreased with increasing a integrating current.<br>When we used copper electro-conductive with low electric resistance, curvature radius was smaller than it used nickel electro-conductive film with high electric resistance.<br>When a hole diameter of photo-resist pattern increased, curvature radius was a large.

収録刊行物

  • 表面技術

    表面技術 49 (12), 1277-1282, 1998

    一般社団法人 表面技術協会

被引用文献 (1)*注記

もっと見る

参考文献 (11)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ