Characterization of Cured Furan Resin Prepared by the High Power Ultrasonic Irradiation
-
- Hoshi Kazuhito
- Materials and Structures Laboratory, Tokyo Institute of Technology
-
- Iiyama Taku
- Faculty of Science, Shinshu University
-
- Akatsu Takashi
- Materials and Structures Laboratory, Tokyo Institute of Technology
-
- Tanabe Yasuhiro
- Materials and Structures Laboratory, Tokyo Institute of Technology
-
- Yasuda Eiichi
- Materials and Structures Laboratory, Tokyo Institute of Technology
書誌事項
- タイトル別名
-
- Characterization of Cured Furan Resin Prepared by High Power Ultrasonic Irradiation
この論文をさがす
抄録
High power ultrasonic wave was applied through the curing process of furfuryl alcohol condensate (furanresin) by using an ultrasonic homogenizer at the frequency of 20 kHz and the intensity of 50 W/cm2. Thestructuralproperties of cured furan resin prepared with and without sonication were examined. Combining the resultsfrom GPCmeasurement, FTIR spectroscopy, elemental analysis and XRD, it was cleared that the sonication was effective forthe increase of curing rate in furan resin, however, the structural change of the cured furan resin did not occur with and without sonication.
収録刊行物
-
- 炭素
-
炭素 1999 (190), 289-292, 1999
炭素材料学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679204477696
-
- NII論文ID
- 130004358419
- 10010837530
-
- NII書誌ID
- AN00140335
-
- ISSN
- 18845495
- 03715345
-
- NDL書誌ID
- 4975940
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可