Irradiation Effect on Tensile Property of F82H IEA and Its Joint in TITAN Project
-
- Hashimoto Naoyuki
- Department of Materials Science and Engineering, Hokkaido University
-
- Oka Hiroshi
- Department of Materials Science and Engineering, Hokkaido University
-
- Muroga Takeo
- National Institute of Fusion Science, Department of Helical Plasma Research, National Institute for Fusion Science
-
- Nagasaka Takuya
- National Institute of Fusion Science, Department of Helical Plasma Research, National Institute for Fusion Science
-
- Kimura Akihiko
- Institute of Advanced Energy, Kyoto University
-
- Ukai Shigeharu
- Department of Materials Science and Engineering, Hokkaido University
-
- Yamamoto Takuya
- Department of Mechanical Engineering, University of California
-
- Sokolov Michail A.
- Oak Ridge National Laboratory
Search this article
Abstract
Under the TITAN project, in order to determine the contributions of different microstructural features to strength and to deformation mode, microstructure of deformed flat tensile specimens of irradiated reduced activation F82H IEA and its joint were investigated by transmission electron microscopy (TEM), following tensile test and fracture surface examination by scanning electron microscopy (SEM). After irradiation, changes in yield strength, deformation mode, and strain-hardening capacity were seen, with the magnitude of the changes dependent on irradiation temperature. Irradiation to F82H IEA at 573 K led to a significant loss of strain-hardening capacity with a large change in yield strength. There was a tendency for a reduction in strain rate to cause a decrease in yield strength and elongation. While, irradiation at 773 K had little effect on strength, but a reduction in strain rate caused a decrease in ductility. SEM revealed fracture surfaces showing a martensitic mixed quasi-cleavage and ductile-dimple fracture in all samples. TEM have exhibited defect free bands (dislocation channels) in the necked region irradiated at 573 K. This suggests that dislocation channeling would be the dominant deformation mechanism in this steel irradiated at 573 K, resulting in the loss of strain-hardening capacity. While, the necked region of the irradiated F82H IEA joint, where showed less hardening than F82H IEA, has showed deformation bands only. From these results, it is suggested that the pre-irradiation microstructure, especially the dislocation density, could affect the post-irradiation deformation mode.
Journal
-
- MATERIALS TRANSACTIONS
-
MATERIALS TRANSACTIONS 54 (4), 442-445, 2013
The Japan Institute of Metals and Materials
- Tweet
Details
-
- CRID
- 1390282679225572224
-
- NII Article ID
- 10031162807
-
- NII Book ID
- AA1151294X
-
- COI
- 1:CAS:528:DC%2BC3sXoslyqur0%3D
-
- ISSN
- 13475320
- 13459678
-
- NDL BIB ID
- 024376168
-
- Text Lang
- en
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
- KAKEN
-
- Abstract License Flag
- Disallowed