Microstructure and wear characteristics of hypoeutectic, eutectic and hypereutectic (Cr,Fe)23C6 carbides in hardfacing alloys

DOI Web Site Web Site 参考文献27件
  • Kuo Che Wei
    National Chung Hsing University, Department of Materials Science and Engineering
  • Fan Chieh
    National Chung Hsing University, Department of Materials Science and Engineering
  • Wu Sheng Hao
    National Chung Hsing University, Department of Materials Science and Engineering
  • Wu Weite
    National Chung Hsing University, Department of Materials Science and Engineering

書誌事項

タイトル別名
  • Microstructure and Wear Characteristics of Hypoeutectic, Eutectic and Hypereutectic (Cr,Fe)<SUB>23</SUB>C<SUB>6</SUB> Carbides in Hardfacing Alloys

この論文をさがす

抄録

This study investigates the microstructure and wear characteristics of hypoeutectic, eutectic and hypereutectic (Cr,Fe)23C6 carbides in hardfacing alloy cladding by using gas tungsten arc welding (GTAW). Chromium and graphite alloy fillers were used to clad ASTM A36 steel substrates. These coatings were specially designed to vary the size and proportion of the (Cr,Fe)23C6 carbides that are present in the microstructure at room temperature. Depending on the amount of graphite used in the alloy filler, a hypoeutectic, eutectic or hypereutectic microstructure was obtained on the coated surface. The wear behavior indicated that the abrasive wear resistance is not only simply related to the hardness of the deposit but that it is also determined by the carbides and matrix structure of the coating. The hypereutectic carbides have the largest (Cr,Fe)23C6 carbide content and the maximum hardness; however, they show the worst wear resistance due to the large particles were dug out during wearing.

収録刊行物

参考文献 (27)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ