The effect of jetting temperature on the fabrication of rapidly solidified Fe-Si-B systems alloys using roller melt spinning

DOI Web Site Web Site 被引用文献2件 参考文献20件

書誌事項

タイトル別名
  • The Effect of Jetting Temperature on the Fabrication of Rapidly Solidified Fe-Si-B Systems Alloys Using Single-Roller Melt Spinning

この論文をさがす

抄録

Fe-Si-B systems amorphous alloys were rapidly solidified from the melt by the single roller method. In this process the alloys were melted in a crucible and the molten alloy is jetted through a small orifice by gas pressure or gravity. The effects of the jetting temperature of the melting alloy on the ribbon thickness of rapidly solidified Fe75Si10B15 and Fe79.5Si8.5B12 alloys were examined. The rapidly solidified Fe75Si10B15 and Fe79.5Si8.5B12 alloy ribbons’ mean thickness decreased continuously with the increased jetting temperature. However, the temperature dependence of the ribbon thickness in the Fe79.5Si8.5B12 alloy was greater than that of the Fe75Si10B15 alloy.<BR>The results demonstrate that the viscosity of liquid Fe-Si-B systems alloys influences the ribbon thickness. Moreover, when the contact conditions between the rotating roll comes and puddle are good, the ribbon thickness decreases.

収録刊行物

被引用文献 (2)*注記

もっと見る

参考文献 (20)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ