Microstructure and Properties of Al0.5CoCrCuFeNiTix (x= 0-2.0) High-Entropy Alloys

DOI Web Site Web Site 被引用文献3件 参考文献22件
  • Chen Min-Rui
    Department of Materials Science and Engineering, National Tsing Hua University
  • Lin Su-Jien
    Department of Materials Science and Engineering, National Tsing Hua University
  • Yeh Jien-Wei
    Department of Materials Science and Engineering, National Tsing Hua University
  • Chen Swe-Kai
    Materials Science Center, National Tsing Hua University
  • Huang Yuan-Sheng
    Department of Materials Science and Engineering, National Tsing Hua University Department of Mechanical and Electronic Engineering, Shaoguan University
  • Tu Chin-Pang
    Materials Research Laboratory, Industrial Technology Research Institute

書誌事項

タイトル別名
  • Microstructure and Properties of Al<SUB>0.5</SUB>CoCrCuFeNiTi<I><SUB>x</SUB></I> (<I>x</I>=0–2.0) High-Entropy Alloys
  • Microstructure and Properties of Al<SUB>0.5</SUB>CoCrCuFeNiTi<I><SUB>x</SUB></I> (<I>x</I>=0&ndash;2.0) High-Entropy Alloys

この論文をさがす

説明

High-entropy Al0.5CoCrCuFeNiTix alloys are synthesized using the well-developed arc-melting and casting method. The molar ratio (x) of titanium is varied from 0 to 2.0. The microstructure, hardness and wear resistance of the alloys are investigated. The alloys exhibit simple FCC, BCC, CoCr-like and Ti2Ni-like phases. For a small addition of titanium, the alloys form a monolithic FCC solid-solution phase. Two phases of β1 and β2 based on BCC appear at the titanium content of x=0.4 and the β1 phase becomes ordered at x=1.4. With the increase of titanium content, copper segregates to the interdendrite region in which nano-precipitates form. A CoCr-like phase forms when x ranges from 0.8 to 1.2. Ti2Ni-like phase forms when the titanium content exceeds x=1.0. The hardness value increases with titanium content. The alloys with lower titanium content exhibit similar wear resistance to Al0.5CoCrCuFeNi. The wear resistance is rapidly improved at titanium contents from 0.6 to 1.0, and reaches a maximum at x=1.0. This is followed by a gradual decrease with further increase of the titanium. The mechanisms behind the strengthening and wear resistance of the alloys are discussed.

収録刊行物

被引用文献 (3)*注記

もっと見る

参考文献 (22)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ