A Planar Gas Sensor Combined with Interdigitated Array Electrodes.

TODA Kei, KOMATSU Yoko, OGUNI Seiki, HASHIGUCHI Shuichi, SANEMASA Isao

doi:10.2116/analsci.15.87

type:論文(Article)

Generally, the gap and width of the electrodes should be small in order to generate a large number of redox cycles. However, it was difficult to fabricate fine patterns on the gas-permeable membrane, because the membrane was flexible and its surface was not flat. On the other hand, it is already possible to fabricate fine IDA patterns on a hard and flat substrate and are already being marketed. However, if these electrodes fabricated on substrate are set in an electrolyte solution, they do not come into contact with the membrane. Therefore, it is said that the sensitivity and response speed are poor. Accordingly, we experimented with a new method of applying IDA electrodes to a gas-sens ing system. We call it a planar IDA gas sensor. A piece of filter paper containing an electrolyte solution was put on IDA electrodes, which were fabricated on a glass substrate. This gas sensor was very easy to construct. A similar planar sensor had been reported for amperometric sensing of oxygen.9 It was developed as a low-cost and disposable sensor, and applied to glucose sensing. A planar sensor is expected to be more useful in complicated detection systems i.e. using IDA electrodes, which was confirmed after being used in a hydrogen-detection system.

source:09106340

identifier:http://www.jsac.or.jp/cgi-bin/analsci/toc/

A Planar Gas Sensor Combined with Interdigitated Array Electrodes.

書誌事項

この論文をさがす

抄録

収録刊行物

被引用文献 (1)*注記

参考文献 (17)*注記

キーワード

詳細情報詳細情報について

書き出し

問題の指摘

A Planar Gas Sensor Combined with Interdigitated Array Electrodes.

書誌事項

この論文をさがす

抄録

収録刊行物

被引用文献 (1)*注記

参考文献 (17)*注記

キーワード

詳細情報 詳細情報について

書き出し

問題の指摘

詳細情報詳細情報について