A Simple Microfluidic Integrated with an Optical Sensor for Micro Flow Injection Colorimetric Determination of Glutathione

DOI PDF Web Site Web Site Web Site ほか1件をすべて表示 一部だけ表示 被引用文献1件 参考文献38件
  • SUPHAROEK Sam-ang
    Department of Chemistry, and Center of Excellence for Innovation in Chemistry, Faculty of Science, Chiang Mai University
  • YOUNGVISES Napaporn
    Department of Chemistry, Faculty of Science and Technology, Thammasat University
  • JAKMUNEE Jaroon
    Department of Chemistry, and Center of Excellence for Innovation in Chemistry, Faculty of Science, Chiang Mai University

この論文をさがす

説明

A simple and inexpensive method for fabricating a microfluidic platform was developed. A printed circuit board (PCB) was used to make a master mold for replicating a polydimethylsiloxane (PDMS) microchannel. The master mold was fabricated by a simple photolithographic method, employing a photoresist dry film. The process did not use hazardous chemicals, a clean room or any expensive instrument. The PDMS microchannel was clamped with polymethylmethacrylate (PMMA) plates, where a light emitting diode (LED) as a light source and a light dependent resistor (LDR) as a light sensor were attached to form a simple optical sensor. The system was successfully employed as a micro flow injection analysis for the determination of glutathione in dietary supplement samples. A linear calibration graph in the range of 5.0 – 60.0 mg L−1 glutathione was obtained with a detection limit of 0.01 mg L−1. The system provided a sample throughput of 48 h−1, with microliter consumption of the reagent.

収録刊行物

  • Analytical Sciences

    Analytical Sciences 28 (7), 651-656, 2012

    社団法人 日本分析化学会

被引用文献 (1)*注記

もっと見る

参考文献 (38)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ