Layered Polymer Light Emitting Diode Prepared by Evaporative Spray Deposition from Ultradilute Solution (ESDUS) Technique at Various Substrate Temperature

DOI Web Site Web Site 参考文献12件
  • Shakutsui Masato
    Department of Applied Science for Electronics and Materials, Graduate School of Engineering Sciences, Kyushu University
  • Fujita Katsuhiko
    Department of Applied Science for Electronics and Materials, Graduate School of Engineering Sciences, Kyushu University Institute for Materials Chemistry and Engineering, Kyushu University
  • Tsutsui Tetsuo
    Department of Applied Science for Electronics and Materials, Graduate School of Engineering Sciences, Kyushu University Institute for Materials Chemistry and Engineering, Kyushu University

この論文をさがす

抄録

The evaporative spray deposition from ultra-dilute solution (ESDUS) technique enables preparing a polymer layered structure. The bi-layer structure consisted of two π-conjugated polymers, where the top layer was deposited from tetrahydrofuran (THF) solution with the ESDUS technique onto the preceding bottom layer composed of the other THF-soluble polymer. It has been reported that the external quantum efficiency (EQE) of the polymer light emitting diode (PLED) having the bi-layer structure is significantly higher than a corresponding single-layer device. In the present study, the polymer bi-layer films are prepared at substrate temperatures of 65 °C and 80 °C. While the photoluminescence of the bi-layer film prepared at 80 °C indicated the separation of the two components in the film, that of the film at 65 °C suggested partially mixed structure. The PLED composed of the film at 80 °C exhibited significantly better performance than that at 65 °C and the PLED composed of the spin-coated mixed film. The mixture structure of the two component films can be controlled simply by the substrate temperature during ESDUS deposition.

収録刊行物

参考文献 (12)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ