高性能リン酸アルミニウム系触媒材料に関する研究  第1報 粉末合成

  • NAGAO Tomomi
    Department of Applied Chemistry, School of Engineering, Tokai University
  • SAKAGUCHI Hideo
    Department of Applied Chemistry, School of Engineering, Tokai University
  • KATO Toshiaki
    Department of Applied Chemistry, School of Engineering, Tokai University
  • MATSUSHITA Jun-ichi
    Department of Applied Chemistry, School of Engineering, Tokai University

書誌事項

タイトル別名
  • The initial investigation for high-performance aluminum phosphate catalyst The first report-powder preparation.
  • The first report—powder preparation—
  • 第1報 ―粉末合成―

この論文をさがす

抄録

Aluminum phosphate (AlPO4) was prepared by the use of two processes that were precipitation method as a classical technique and alkoxide method as a novel approach. Aluminum nitrate hydrate and ortho-phosphoric acid aqueous solution were used as raw materials for precipitation method. Aluminum tri-i-propoxide and ortho-phosphoric acid anhydrous were used as starting materials for alkoxide method. 2-Methoxyethanol was used as solvent. The products in each process were dried for 24h at 393K and then were sintered for 3h at various temperatures in air. As a result of X-ray powder diffraction analysis, it was observed that crystallization occurred above 1273K in precipitation process, but 973K in alkoxide process.

収録刊行物

参考文献 (1)*注記

もっと見る

詳細情報 詳細情報について

  • CRID
    1390282679319767808
  • NII論文ID
    10014141359
  • NII書誌ID
    AA11948435
  • DOI
    10.2978/jsas.12.107
  • ISSN
    18813917
    09155651
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • Crossref
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ