メタリック調射出成形品における光輝材混合比の画像解析による識別

DOI Web Site Web Site 被引用文献1件 参考文献1件

書誌事項

タイトル別名
  • Identification of Mixing Ratios of Metallic Flakes in Metallic Color Products Injection-Molded by Image Analysis
  • メタリックチョウシャシュツ セイケイヒン ニ オケル コウキザイ コンゴウヒ ノ ガゾウ カイセキ ニ ヨル シキベツ

この論文をさがす

抄録

The exterior components are often painted with metallic color. However, painting increases the cost and environmental impact. So, manufacturing technology that makes metallic-colored plastic parts by injection molding without painting is being developed by many companies. But color unevenness hinders commercialization. In this study, we focused on the dispersion of metallic flakes that cause uneven color in metallic molding and investigated in order to evaluate the dispersion. We made test pieces with different sizes of metallic flakes by injection-molding and evaluated influence of proportion of metallic flakes on the qualities of plastic parts. We took the test pieces using a CCD microscope and compared the results of image analysis. We selected skewness (SKEW),angular second moment (ASM) and entropy (ENT) as values that indicate the features of the image. The following conclusions were obtained. (1) When the ratio of metallic flakes increased, flakes that are present at a position near surface increased. In the gray level histogram, SKEW decreased. The results of the analysis by co-occurrence matrix, ENT increased. (2) When the size of metallic flakes increased, SKEW increased. The results of the analysis by co-occurrence matrix, ASM increased. (3) It was considered that the difference of the ratio and the size of metallic flakes affected the results of image analysis. (4) It was suggested that gray level histogram and co-occurrence matrix were useful for evaluating the dispersion of metallic flakes.

収録刊行物

  • 成形加工

    成形加工 27 (3), 109-117, 2015-02-20

    一般社団法人 プラスチック成形加工学会

被引用文献 (1)*注記

もっと見る

参考文献 (1)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ