高圧水素ガス環境下におけるEPDMのブリスタ発生限界の推定

  • 山辺 純一郎
    九州大学大学院工学研究院:(独)産業技術総合研究所HYDROGENIUS
  • 西村 伸
    九州大学工学研究院:(独)産業技術総合研究所HYDROGENIUS

書誌事項

タイトル別名
  • Estimation of Hydrogen Pressure at Blister Initiation of EPDM Composite Exposed to High Pressure Hydrogen Gas
  • コウアツ スイソ ガス カンキョウ カ ニ オケル EPDM ノ ブリスタ ハッセイ ゲンカイ ノ スイテイ

この論文をさがす

抄録

Transparent EPDM composite crosslinked by peroxide with no fillers was exposed to hydrogen gas at a maximum pressure of 10MPa, and then the behavior of blister initiation and growth in the composite after decompression was observed by an optical microscope. The critical pressure where no blisters initiated P_<H,cr> was 1-2MPa, while micrometer-sized blisters initiated in the composite at P_H>1-2MPa. It is considered that these blisters initiated due to stress concentration of micrometer-sized bubbles under an inner pressure II formed by supersaturated hydrogen molecules after decompression; then the energy release rate-tearing energy, T-of these bubbles was calculated theoretically or by FEM. Parallel to the calculation, static crack growth tests were conducted, and the threshold tearing energy for the static crack T_<S,th> was experimentally obtained. From the criterion expressed by T>T_<S,th>, the inner pressure at blister initiation II_F was estimated and then was compared with P_<H,cr>. Consequently, II_F&ap;P_<H,cr>, i.e., the critical pressure where no blisters initiated was successfully estimated in terms of fracture mechanics.

収録刊行物

被引用文献 (3)*注記

もっと見る

参考文献 (49)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ