- 【Updated on May 12, 2025】 Integration of CiNii Dissertations and CiNii Books into CiNii Research
- Trial version of CiNii Research Knowledge Graph Search feature is available on CiNii Labs
- 【Updated on June 30, 2025】Suspension and deletion of data provided by Nikkei BP
- Regarding the recording of “Research Data” and “Evidence Data”
Misorientation Analysis of Plastic Deformation of Austenitic Stainless Steel by EBSD and X-Ray Diffraction Methods
-
- KIMURA Hidehiko
- Department of Mechanical Science and Engineering, Nagoya University
-
- WANG Yun
- 名古屋大学大学院工学研究科
-
- AKINIWA Yoshiaki
- Department of Mechanical Science and Engineering, Nagoya University
-
- TANAKA Keisuke
- Department of Mechanical Science and Engineering, Nagoya University
Bibliographic Information
- Other Title
-
- EBSD法およびX線回折法によるステンレス鋼の塑性変形におけるミスオリエンテーションの解析
- EBSDホウ オヨビ Xセン カイセツホウ ニ ヨル ステンレス コウ ノ ソセイ ヘンケイ ニ オケル ミスオリエンテーション ノ カイセキ
Search this article
Description
The misorientation introduced into an austenitic stainless steel (SUS 316) by plastic deformation was masured with the electron back scattering diffraction (EBSD) and the X-ray diffraction (XRD) techniques. Three parameters related to miorientation distribution, i.e. grain orientation spread (GOS), grain average misorientation (GAM) and kernel average misorientation (KAM), were calculated from the orientation measurements by EBSD. The misorienation between neighboring measured points, KAM, was larger close to the grain boundary where the slip propagation was difficult. The average of misorientation between neighboring points within one grain is GAM. The GAM value averaged over the measured reagion increased proportionally with the plastic strain to about 20%, and leveled off at higher strains. The average of the misorientation spread within one grain, GOS, also showed similar increase like GAM. The total misorientation of a grain measured by XRD also showed a proportional increase with the plastic strain to about 10%, and it was difficult to measure the total misorientation above that strain because Debye ring became continuous ring. Both EBSD and XRD can be used as a tool to measure the plastic strain in the local area, and the limit of strain to be measured was 30% for the former and 10% for the latter.
Journal
-
- TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
-
TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A 71 (712), 1722-1728, 2005
The Japan Society of Mechanical Engineers
- Tweet
Keywords
Details 詳細情報について
-
- CRID
- 1390282679454029312
-
- NII Article ID
- 110004999140
-
- NII Book ID
- AN0018742X
-
- COI
- 1:CAS:528:DC%2BD28XhslCju7g%3D
-
- ISSN
- 18848338
- 03875008
- http://id.crossref.org/issn/03875008
-
- NDL BIB ID
- 7777106
-
- Text Lang
- ja
-
- Article Type
- journal article
-
- Data Source
-
- JaLC
- NDL Search
- Crossref
- CiNii Articles
- KAKEN
- OpenAIRE
-
- Abstract License Flag
- Disallowed