Development of a deep-sea mercury sensor using in situ anodic stripping voltammetry
-
- Yamamoto Masahiro
- Research and Development Center for Submarine Resources, Japan Agency for Marine-Earth Science and Technology (JAMSTEC)
-
- Kodamatani Hitoshi
- Graduate School of Science and Engineering, Kagoshima University
-
- Kono Yuriko
- Environment and Safety Center, Kagoshima University
-
- Takeuchi Akinori
- Center for Environmental Measurement and Analysis, National Institute for Environmental Studies (NIES)
-
- Takai Ken
- Research and Development Center for Submarine Resources, Japan Agency for Marine-Earth Science and Technology (JAMSTEC)
-
- Tomiyasu Takashi
- Graduate School of Science and Engineering, Kagoshima University
-
- Marumo Katsumi
- Depertment of Environmental Biology and Chemistry, Toyama University
書誌事項
- タイトル別名
-
- Development of a deep-sea mercury sensor using <i>in situ</i> anodic stripping voltammetry
この論文をさがす
説明
Development of submarine resource may occur pollution of mercury in the ambient seawater. It is useful if there is a handy mercury-monitoring tool for deep-sea. We developed a deep-sea mercury sensor based on an anodic striping voltammetry method. To enhance the sensitivity of the sensor to mercury in seawater, we used a large gold-ring disc with a surface area of 402 mm2 as a working electrode. In addition, a propeller screw was located in front of the working electrode to create water flow and enhance the electrodeposition efficiency of the mercury. The sensor was able to detect peak current, depending on the mercury concentration in a 0.6 M sodium chloride solution in a test water container with 0.94 ng L–1 (ppt) of the lowest detection limit (deposition time was 20 min), which was lower than 800 ng L–1 of the lowest detection limit with an electrode surface area of 20 mm2. We were then successful in in-situ measurement of mercury at the ppt level in the sea, coordinating with another measurement using the cold vapor atomic fluorescence spectrometry method. Accurate calibration was difficult for the sensor in the labo-scale. It is necessary to build another calibration method without a large volume of standard solution in the future. In addition, the sensor does not fully work in H2S-rich environments (more than about 1 μmol L–1) adjacent to hydrothermal fluid discharges. In spite of the weak points, this sensor will be a very useful tool for wide-range monitoring mercury in seawater.
収録刊行物
-
- GEOCHEMICAL JOURNAL
-
GEOCHEMICAL JOURNAL 49 (6), 613-620, 2015
一般社団法人日本地球化学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282679530957696
-
- NII論文ID
- 130005112466
-
- NII書誌ID
- AA00654975
-
- ISSN
- 18805973
- 00167002
-
- NDL書誌ID
- 026964772
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可