A Lattice Boltzmann Simulation of Contact Line Motion and Internal Fluid Flows in an Evaporating Droplet on Homogenous Substrates
-
- Li Rong-Juan
- Graduate School of Engineering, Kochi University of Technology
-
- Morozumi Yoshio
- School of System Engineering, Kochi University of Technology
この論文をさがす
説明
A two-dimensional lattice Boltzmann model is constructed to simulate the evaporation of a single droplet on a homogenous wetting substrate. An evaporation model is used in the simulation to describe the mass loss from the surface of the evaporating droplet. In addition, a partial wetting boundary condition is imposed on the lattice sites on the substrate surface to determine the wettability of the substrate. The evaporation of a single droplet in ambient vapor shows a linear decrease in the square of the droplet radius, which agrees well with the d2 law for an evaporating droplet. During the evaporation of a droplet on a hydrophobic substrate, the wetting diameter decreases while the contact angle remains constant. During the evaporation of a droplet on a hydrophilic substrate, the wetting diameter decreases while the contact angle remains almost constant when a partial wetting boundary condition is imposed. However, three stages of contact line motion are observed when the partial wetting boundary condition is modified to describe the dynamical change in the contact angle, and this observation agrees well with a previous study by other investigtors. In addition, internal fluid flows towards the contact line of the droplet in the pinning stage of the evaporation are discussed.
収録刊行物
-
- JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
-
JOURNAL OF CHEMICAL ENGINEERING OF JAPAN 45 (3), 155-165, 2012
公益社団法人 化学工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282679546367744
-
- NII論文ID
- 130001307433
-
- NII書誌ID
- AA00709658
-
- COI
- 1:CAS:528:DC%2BC38XlslOkt70%3D
-
- ISSN
- 18811299
- 00219592
-
- NDL書誌ID
- 023514265
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可