Supported Liquid Membrane Extraction of Reactive Dye Using Fabricated Polypropylene Membrane
-
- Harruddin Norlisa
- Center of Lipids Engineering and Applied Research (CLEAR), Department of Chemical Engineering, Faculty of Chemical Engineering, Universiti Teknologi Malaysia
-
- Othman Norasikin
- Center of Lipids Engineering and Applied Research (CLEAR), Department of Chemical Engineering, Faculty of Chemical Engineering, Universiti Teknologi Malaysia
-
- Idris Ani
- Institute of Bioproduct Development (IBD), Department of Bioprocess Engineering, Faculty of Chemical Engineering, Universiti Teknologi Malaysia
-
- Ooi Zing Yi
- Center of Lipids Engineering and Applied Research (CLEAR), Department of Chemical Engineering, Faculty of Chemical Engineering, Universiti Teknologi Malaysia
-
- Goto Masahiro
- Department of Applied Chemistry, Graduate School of Engineering, Kyushu University
この論文をさがす
抄録
This study investigates the transport of dye ions across a supported liquid membrane (SLM) by using tridodecylamine as a carrier and sodium hydroxide (NaOH) as a stripping agent. A microporous polypropylene membrane was used as a membrane support and prepared by the thermal induced phase separation (TIPS) technique. Two different TIPS techniques were used when preparing membranes: solidification and without solidification with polymer concentrations varied at 10, 15 and 20%. The results revealed that both techniques produced membranes with similar morphologies, but different pore size structures. The membrane with 15% polymer concentration which was prepared by the solidification technique produced a microporous membrane with a symmetric structure, defined pore size and high stability, and thus is feasible as the support material. The fabricated membrane was tested and the results revealed that 100% of reactive dyes was succesfully removed with 58% recovery from an aqueous solution. The fabricated membrane also exhibited high stability up to 25.5 h of extraction, thereby demonstrating an improved method for the separation of reactive dyes using a SLM.
収録刊行物
-
- JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
-
JOURNAL OF CHEMICAL ENGINEERING OF JAPAN 47 (10), 761-769, 2014
公益社団法人 化学工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282679546670464
-
- NII論文ID
- 130004699179
-
- NII書誌ID
- AA00709658
-
- ISSN
- 18811299
- 00219592
-
- NDL書誌ID
- 026001335
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可