Array antenna fed by coplanar waveguide.

DOI Web Site
  • KITAOKA Hiroshi
    Department of Electrical Engineering, Faculty of Science and Technology, Science University of Tokyo
  • MOTOYAMA Shin-ichi
    Department of Electrical Engineering, Faculty of Science and Technology, Science University of Tokyo
  • HISATOMI Teruhiro
    Department of Electrical Engineering, Faculty of Science and Technology, Science University of Tokyo
  • KOSHIJI Kohji
    Department of Electrical Engineering, Faculty of Science and Technology, Science University of Tokyo
  • SHU Eimei
    Department of Electrical Engineering, Faculty of Science and Technology, Science University of Tokyo

Bibliographic Information

Other Title
  • 共平面形線路を用いたアレーアンテナについて

Abstract

In this paper are presented two types of printed array antennas fed with a coplanar waveguide. One type uses strips of conductor, and the other uses slots cut in the ground plane, as the radiating elements. One advantage of these constructions is that both the radiating elements and feeding lines can be formed in the same plane on one side of the substrate, thus allowing the use of a reflector plane to enhance gain, or stacking of several such antennas. In order to obtain an optimum design, antenna gains and bandwidth are measured for various design parameters. These include (1) width of inner conductor of the feeding coplanar waveguide, (2) gap width between the feeding line and radiating element, and (3) slot width.

Journal

  • Circuit Technology

    Circuit Technology 4 (1), 6-11, 1989

    The Japan Institute of Electronics Packaging

Keywords

Details 詳細情報について

Report a problem

Back to top