Fracture resistance of premolars with one remaining cavity wall restored using different techniques
-
- KIVANÇ Bagdagül Helvacioglu
- Department of Operative Dentistry and Endodontics, Faculty of Dentistry, Gazi University
-
- ALAÇAM Tayfun
- Department of Operative Dentistry and Endodontics, Faculty of Dentistry, Gazi University
-
- GÖRGÜL Güliz
- Department of Operative Dentistry and Endodontics, Faculty of Dentistry, Gazi University
この論文をさがす
抄録
The aim of the study was to compare the fracture resistance of maxillary premolars with one remaining cavity wall restored using different post systems. Forty-eight maxillary premolars were endodontically treated and randomly assigned to four groups for postcore restoration. The first three test groups were restored with polyethylene woven fiber posts, custom-made glass fiber-reinforced composite posts, and titanium posts respectively. In the control Group 4, standardized cavities (3.5×1.5 mm) were prepared in the palatal canal entrance and filled with a resin composite. All the specimens were then restored with a resin composite crown seated on the post. Load was applied with a stainless steel ball (1 mm/min), and the failure modes of all specimens were evaluated. There were no significant differences in fracture resistance and failure mode among the different restorative materials (p>0.05). Within the limitations of this in vitro study, it was concluded that the presence and type of post did not influence the fracture load and failure mode of maxillary premolar teeth with one remaining cavity wall.
収録刊行物
-
- Dental Materials Journal
-
Dental Materials Journal 29 (3), 262-267, 2010
一般社団法人 日本歯科理工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679692900864
-
- NII論文ID
- 10026470120
-
- NII書誌ID
- AA10443149
-
- ISSN
- 18811361
- 02874547
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可