書誌事項
- タイトル別名
-
- Automatic non-contact measurement of lead accuracy in the bobbin for electric standard use.
- デンキ ヒョウジュンヨウ ボビン ノ リード セイド ノ ヒ セッショク ジド
この論文をさがす
説明
In order to establish the electric standard system, which was renewed in 1977 in Japan, a precision solenoid for electric standard use, manufactured by winding a copper wire on a quartz bobbin having threads, is required. In the first stage, the lead accuracy of the bobbin was measured using two electric comparator's gauge heads as contact feelers. But this method of measurement has some problems. That is, threads on the bobbin are easy to be damaged during the measurement and it takes a lots of time in the measurement. Therefore, in order to solve these problems, the non-contact feelers are introduced, which consist of microscope, pin photodiode and amplifier. The main results in this reports are as follows : (1) The non-contact measurement of the threads having a large diameter and a small pitch is made possible. (2) The precision of measurement for repeatability expressed by the standard deviation is 0.22 μm at maximum. (3) The results in the measurement of cumulative pitch accuracy using non-contact feelers and contact feelers show the same trend in the regression analysis using the method of least squares. (4) The measuring time for cumulative pitch accuracy is shortened to 1/10 compared with that in the case of contact feelers.
収録刊行物
-
- 精密機械
-
精密機械 51 (9), 1789-1794, 1985
公益社団法人 精密工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679708305920
-
- NII論文ID
- 130003962554
- 110001292296
-
- NII書誌ID
- AN00130014
-
- NDL書誌ID
- 3039216
-
- ISSN
- 03743543
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDLサーチ
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可