真円度測定における精度と測定点数の関係

DOI Web Site 被引用文献1件

書誌事項

タイトル別名
  • Relation between the number of measured points and the uncertainty of the estimated roundness.
  • シンエンド ソクテイ ニ オケル セイド ト ソクテイ テンスウ ノ カンケイ

この論文をさがす

説明

It is important to clarify the difference between the true shape of the workpiece and the shape estimated from the chain of measured points, in the three-coordinate measuring machines. In this paper, the roundness was dealt, first of all. Using "min-max method", the evaluation program was made based on the minimum zone conception. Then the roundness was numerically calculated changing the phase of the starting point of the measurementand the sampling interval (number of measured points). As a result, some remarkable facts have been clarified as follows. The decrease of the uncertainty of the calculated roundness, according to the number of measured points. The lower uncertainty less than intended value, as selection of the number of measured points, in the case where the shape was made only from the highest order of frequency component. Namely, the number of measured points N is given as N=2.2M/√G, where M is the highest order of frequency component, and G is the uncertainty.

収録刊行物

  • 精密機械

    精密機械 50 (12), 1881-1884, 1984

    公益社団法人 精密工学会

被引用文献 (1)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ