書誌事項
- タイトル別名
-
- Difference in Grinding Mechanism between Up- and Down-cut Creep Feed Grindings
- クリープ フィード ケンサク ニ オケル ウワムキ オヨビ シタムキ ケンサク
この論文をさがす
抄録
This paper aims to reveal the difference in grinding mechanism between up- and down-cut creep feed grindings. According to the experiments, both the normal and tangential components of mean grinding force have always become larger in up-cut than in down-cut under the usual creep feed grinding conditions, and the difference has become 1. 7 times at maximum. It was found from the force measurements on a single grain that its normal to tangential ratio remained constant at about 2.5 throughout a grain-workpiece engagement in down-cut, but it became up to about 7 at the beginning of engagement in up-cut, which implies much occurrences of rubbing and/or plowing, hence leading to a larger grinding force. Then it is introduced that this mean grinding force at down-cut can be estimated quantitatively from the conventional grinding force data.
収録刊行物
-
- 精密機械
-
精密機械 45 (533), 599-606, 1979
公益社団法人 精密工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679740864256
-
- NII論文ID
- 130003961501
- 110001290628
-
- NII書誌ID
- AN00130014
-
- NDL書誌ID
- 2051907
-
- ISSN
- 03743543
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可