Measurement of Tool Face Temperature in Orthogonal Diamond Cutting.
-
- SATO Masahiko
- 正会員 富山県立大学工学部
-
- UEDA Takashi
- 正会員 金沢大学工学部
-
- NISITA Masahiro
- 学生会員 金沢大学大学院 (現, (株) 北陸電力)
Bibliographic Information
- Other Title
-
- 単結晶ダイヤモンド二次元切削における工具すくい面温度の測定
- タンケッショウ ダイヤモンド 2ジゲン セッサク ニ オケル コウグ スクイメ
Search this article
Abstract
Tool face temperature of single crystal diamond in high precision orthogonal cutting of aluminum and copper is measured using two-color pyrometer with an optical fiber. The infrared rays radiated from the chip-tool interface and transmitted through the diamond tool are accepted by an optical fiber and led to two-color detectors of different spectral sensitivity. Temperature distribution on the tool face is analyzed by employing finite element method and calculated results are applied to the estimation of the maximum temperature on the tool face. The results obtained are as follows; (1) The technique developed is suitable for measuring the tool face temperature in single crystal diamond cutting. (2) Output wave of temperature was clearly recorded. The tool face temperature measured is approximately 190°C for Al and approximately 220°C for Cu when cutting speed was about 620m/min. (3) The temperature increases with the increase of cutting speed. (4) The temperature on the tool face measured is in good agreement with that calculated.
Journal
-
- Journal of the Japan Society for Precision Engineering
-
Journal of the Japan Society for Precision Engineering 64 (6), 892-896, 1998
The Japan Society for Precision Engineering
- Tweet
Keywords
Details 詳細情報について
-
- CRID
- 1390282679742374656
-
- NII Article ID
- 120005461107
- 110001367958
- 10003572248
-
- NII Book ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
- http://id.crossref.org/issn/09120289
-
- NDL BIB ID
- 4491906
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- IRDB
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed