Development of a High-Speed and High-Accuracy Measurement System for Micro Edge Radius of Long Precision Tool
-
- MOTOKI Takenori
- 東北大学大学院
-
- GAO Wei
- 東北大学工学研究科
-
- FURUKAWA Masaru
- 東北大学大学院(現(株)日立製作所)
-
- KIYONO Satoshi
- 東北大学工学研究科
Bibliographic Information
- Other Title
-
- 長尺工具マイクロエッジ半径の高精度高速計測システムの開発
- チョウシャク コウグ マイクロ エッジ ハンケイ ノ コウセイド コウソク ケイソク システム ノ カイハツ
Search this article
Abstract
This paper describes a measurement system for the edge radius of a long precision tool. A line-CCD camera is employed to scan the tool edge over the entire tool length. The edge width of the tool at each scanning point is first evaluated from the image of the line-CCD camera. The edge radius is then calculated from the edge width based on the calibration results using pin gauges. A multi-line scanning method is proposed to reduce the defocus errors caused by the out-of-straightness error of the scanning stage. Experimental results have shown that the edge radii over the entire length of a 5100 mm long tool can be evaluated in 30 minutes.
Journal
-
- Journal of the Japan Society for Precision Engineering
-
Journal of the Japan Society for Precision Engineering 73 (7), 823-827, 2007
The Japan Society for Precision Engineering
- Tweet
Details 詳細情報について
-
- CRID
- 1390282679772621056
-
- NII Article ID
- 110006342952
-
- NII Book ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL BIB ID
- 8890607
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed