書誌事項
- タイトル別名
-
- Study on Cutting-off used Tipped-Saw when Sawing Steels. (1st Report). New Tensioning Methods and Property of Disk.
- チップソー ニ ヨル テッコウ ザイリョウ ノ セツダン カコウ ニ カンスル ケンキュウ ダイ1ポウ アタラシイ テンショニングホウ ト シンバン ノ トクセイ
- New Tensioning Methods and Property of Disk
- 新しいテンショニング法と親板の特性
この論文をさがす
説明
An operation called 'tensioning' is performed on the disk of tipped-saw used in the cutting-off process in order to add a residual tensile stress and to raise consequently a natural frequency. The conventional tensioning method which deforms plastically the disk by roller and/or hammer requires a very high skill. This paper proposes two tensioning methods as named 'expansion fit' and 'internal pressure' in order to simplify the operation, and investigates the property of disk such as natural frequency, rigidity etc. In addition, the cutting-off performance of these tipped-saws is compared with that of the conventional method. The new methods proposed can prepare an adequate residual stress in the disk and consequently increase the natural frequency and the rigidity as same as the conventional method. When sawing S45C steel under low cutting speed, however, the cutting edge has broken down due to large amplitude of run-out of the disk and high sawing force from the beginning of sawing.
収録刊行物
-
- 精密工学会誌
-
精密工学会誌 68 (1), 108-112, 2002
公益社団法人 精密工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679772795264
-
- NII論文ID
- 110001373278
- 10010183932
-
- NII書誌ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL書誌ID
- 6032875
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可
