焼入鋼のエンドミル加工に関する研究 2  工具経路の移行部を含む曲線切削時の切削抵抗の一定化制御

書誌事項

タイトル別名
  • A Study on End Milling of Hardened Steel(2nd Report). Control for Constant Cutting Forces in Corner Profile End Milling Including Transitional Sections of Tool Paths.
  • ヤキイレ コウ ノ エンドミル カコウ ニ カンスル ケンキュウ 2 コウグ ケイロ ノ イコウブ オ フクム キョクセン セッサクジ ノ セッサク テイコウ ノ イッテイカ セイギョ
  • Control for Constant Cutting Forces in Corner Profile End Milling Including Transitional Sections of Tool Paths
  • 工具経路の移行部を含む曲線切削時の切削抵抗の一定化制御

この論文をさがす

抄録

In this paper, the proposed model for cutting forces during end milling of hardened steel is verified for its general usefulness by applying this model to the extended cutting conditions and other applications. The cutting conditions discussed here include concave contour cuttings with a small radius compared to that of the end mill. For this purpose, the operability region by two variables of the arc length of cutting engagement (L) and the maximum undeformed chip thickness(tm) is divided into a few regions of interest which correspond to the cutting conditions geometrically. The control of cutting forces in profile end milling using quadratic polynomials obtained in each region based on response surface methodology was fairly effective. Furthermore, this prediction model was applied for the case of transitional sections of tool paths where the cutting force changes rapidly with the change of feed rate and geometrical conditions, and it was found that the prediction and control of cutting forces was also possible for this problem.

収録刊行物

  • 精密工学会誌

    精密工学会誌 67 (8), 1294-1298, 2001

    公益社団法人 精密工学会

被引用文献 (7)*注記

もっと見る

参考文献 (5)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ