書誌事項
- タイトル別名
-
- Study on Material Removal Process in Electrolytic Grinding.
- デンカイ ケンサク カコウ ニ オケル ザイリョウ ジョキョ トクセイ ニ カンスル ケンキュウ
この論文をさがす
抄録
In this paper, the material removal mechanism in electrolytic grinding process is experimentally investigated by analyzing the stock removal due to electrolytic phenomenon and to grinding phenomenon in electrolytic grinding process, taking the inevitable accumulation phenomenon of interference depth of wheel into consideration. The material removal effect in electrolytic grinding is also discussed from the viewpoint of machining energy. Main conclusions obtained in this paper are as follows: (1) The electric current in electrolytic grinding process increases from beginning of wheel interference because of the momentary short circuit or electric discharge through generated chips at smaller concentration of electrolyte or applied voltage. Therefore all electric current isn't always consumed for the electrolytic effect. (2) There exists the critical electrolytic conditions from which the electrolytic effect in electrolytic grinding process intensifies. (3) The total consumed energy reduces with the increase of concentration of electrolyte or the applied voltage, but the effective energy rate for material removal decreases at about 7V in applied voltage.
収録刊行物
-
- 精密工学会誌
-
精密工学会誌 67 (1), 120-125, 2001
公益社団法人 精密工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282679773933184
-
- NII論文ID
- 110001373000
- 10011634729
-
- NII書誌ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL書誌ID
- 5629204
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可