薄形外周刃砥石による精密研削切断に関する研究 (第1報)

DOI Web Site

書誌事項

タイトル別名
  • Studies on Outer-blade Slicing (1st Report)
  • 薄形外周刃砥石による精密研削切断に関する研究-1-研削抵抗と砥石の摩耗について
  • ウスガタ ガイシュウバ トイシ ニ ヨル セイミツ ケンサク セツダン ニ カ
  • Grinding Force and Wheel Wear
  • 研削抵抗と砥石の摩耗について

この論文をさがす

抄録

The outer-blade slicing parallels the cut-off grinding and the creep-feed grinding in configuration. But it quite differs from them in that a very thin cutting blade is used, which undergoes an elastic deformation. From this viewpoint experimental studies have been carried out using GC grit blades 0.5mm thick and the following results are obtained. (1) An upward grinding force occurs in up-cut slicing process, which may be due to side face grinding following the elastic deformation of blade. (2) The upward grinding force has a usual sensitivity for grinding conditions. (3) Attritious wear predominates in the wheel wear under a small v/V ratio, while bond fracture does under a large v/V ratio. (4) The grinding performance of cutting edges on the side face has an important influence on chipping of the workpiece.

収録刊行物

  • 精密工学会誌

    精密工学会誌 53 (7), 1051-1056, 1987

    公益社団法人 精密工学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ