低炭素鋼におけるγ→α変態域圧延効果の基礎的研究

書誌事項

タイトル別名
  • Effects of the Intercritical Rolling on Structure and Properties of Low Carbon Steel
  • 低炭素鋼におけるγ-α変態域圧延効果の基礎的研究
  • テイ タンソ コウ ニ オケル ガンマ アルファ ヘンタイイキ アツエン コウ

この論文をさがす

抄録

Recovery and recrystallization behavior of ferrite during and after intercritical roiling have been investigated in low carbon steel, using laboratory mill. The results obtained are as follows:<BR>(1) Dynamic recrystallization of ferrite occurs in the intercritical rolling with such a high reduction as about 80 per cent.<BR>(2) Dynamically recovered ferrite structure formed during the intercritical rolling is very stable as compared with that formed in the rolling below Ar1.<BR>(3) Fine ferrite-pearlite structure is obtained from austenite worked in the intercritical range. Making use of these beneficial effects of the intercritical roiling, strong and tough steel can be produced by heating at reduced temperature, followed by the rolling both in the lower temperature range of austenite and subsequent intercritical range where the fraction of transformed ferrite is less than that of non-transformed antenite. It is also necessary, for this purpose, that the rolled products are air cooled or heat treated at the temperature below Ar1. The total molling meduction being kept same, the properties of steel obtained by intercritical multipass rolling are nearly equivalent to those obtained by single pass rolling.

収録刊行物

  • 鉄と鋼

    鉄と鋼 65 (9), 1400-1409, 1979

    一般社団法人 日本鉄鋼協会

参考文献 (3)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ