18%Niマルエージ鋼のプレス成形性に対する変態誘起塑性の効果

DOI Web Site Web Site

書誌事項

タイトル別名
  • Effect of Transformation Induced Plasticity on the Press Formability of 18%Ni Maraging Steels
  • 18パーセント Ni マルエージ コウ ノ プレス セイケイセイ ニ タイスル

この論文をさがす

抄録

The effect of transformation induced plasticity on the press formability has been experimentally investigated at various temperatures and strain rates for 18% Ni maraging steels. The results obtained are as follows.<BR>(1) The best formability is obtained at 225°C (498 K) for 210kg/mm2 class maraging steel and 275°C (548 K) for 245 kg/mm2 class one under various formability tests as deep-drawing, stretching, burring and bending.<BR>(2) The forming limits of the formability tests mentioned above agree relatively well with the values from the Forming Limit Diagram (F.L.D.) which represents the forming limit at two dimensional stress states. However, when the work-piece is subject to strain gradient or is restricted by tool as in the case of burring test, the forming limit is higher than the value from the F.L.D.<BR>(3) The effect of strain rate on the forming limit is not recognized experimentally in the almost all stress states expect for uniaxial stress state in the F.L.D. This phenomenon depends on that the heat of deformation transfers to the tool rapidly, when the work-piece is in contact with the tool.

収録刊行物

  • 鉄と鋼

    鉄と鋼 65 (8), 1186-1193, 1979

    一般社団法人 日本鉄鋼協会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ