書誌事項
- タイトル別名
-
- Theoretical Analysis of the Tup Motion of a Forging Air Hammer : 2nd Report, The Relation between the Characteristics of the Tup Motion and the Most Adaptive Speed of Crank Shaft, etc.
- クウキ ハンマタップ ウンドウ ノ リロン カイセキ 2
この論文をさがす
抄録
In the first report the foundamental equation about characteristics of the tup motion was replaced with the algebraic simultaneous equations of higher order applying successive approximation of integral, and their approximate solution was obtained. Now in this case several numerical calculations for a 500 kg air hammer of Beche type are attempted through the solution as follows. Characteristics of the tup motion are to be influenced by the speed of crank shaft driving the pump piston and the most adaptive or the principal speed which means that one cycle of single blow accords with one cycle of pump piston, is to be found. Moreover the torque of crank shaft, the air pressure and temperature in both cylinders are calculated. And then referring to the desertation of experimental research "Untersuchung eines Schmiede-lufthammers" the writer has found that characteristic curves obtained by our analysis are similar to these experimental records researched through the reliable installations with pickup, indicator and recorder.
収録刊行物
-
- 日本機械学會論文集
-
日本機械学會論文集 26 (164), 628-638, 1960
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282680132241408
-
- NII論文ID
- 110002351170
-
- NII書誌ID
- AN00187419
-
- ISSN
- 21859485
- 00290270
-
- NDL書誌ID
- 9150552
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可