Cutting the Parallel Depth Bevel Gears on Gleason's Spiral Bevel Gear Generator : 2nd Report, Tooth Bearing Adjustment

DOI Web Site Web Site

Bibliographic Information

Other Title
  • グリーソン・スパイラル・ベベル盤による等高歯かさ歯車の歯切法 : 第2報 当り調整法
  • グリーソン スパイラル ベベルバン ニ ヨル トウコウシ カサハグルマ ノ ハギリホウ 2

Search this article

Description

It was stated in full on my 1st Report that if the parallel depth bevel gears were cut on Gleason's spiral bevel gear generator, the machine setting and cutter used were very simple and we could get easily the good spiral bevels with high accuracy. Then, the bad tooth bearings appear in very few cases caused by the unexpected factors. Those bad tooth bearings, however, may be easily corrected, for the numerical relations between the setting errors and the tooth bearing position are researched and stated in this paper. These relations can be applied to the tooth bearing control of assembling too. Then the tooth bearing adjustment of parallel depth bevel gears can be performed accurately and rapidly, outdoing the conventional trial method.

Journal

Details 詳細情報について

Report a problem

Back to top