低炭素普通鋼の冷却中の変態進行の定式化

  • 末広 正芳
    新日本製鉄(株)八幡技術研究部
  • 瀬沼 武秀
    新日本製鉄(株)薄板研究センター東田分室Dr.Ing
  • 矢田 浩
    新日本製鉄(株)薄板研究センター東田分室 工博
  • 松村 義一
    新日本製鉄(株)薄板研究センター東田分室(現:新日本製鉄(株)名古屋技術研究部)
  • 有吉 敏彦
    新日本製鉄(株)熱工学研究センター

書誌事項

タイトル別名
  • A Kinetic Model for Phase Transformations of Low Carbon Steels during Continuous Cooling
  • テイ タンソ フツウ コウ ノ レイキャクチュウ ノ ヘンタイ シンコウ ノ

この論文をさがす

抄録

A calculation model for predicting the progress of transformations of low carbon steels during continuous cooling and the microstructure after cooling has been developed. In this model, the progress of tranformations is assumed as follows. The transformation from austenite to ferrite starts at the equilibrium temperature, Ae3. The ferrite transformation follows 'nucleation and growth' model at the early stage and then follows 'site saturation' model at the later stage. The carbon content of the untransformed austenite increases with the progress of ferrite transformation. The pearlite transformation starts when the carbon content of the austenite reaches the extrapolated Acm line in the equilibrium diagram. The bainite transformation starts when the temperature reaches the bainite-start temperature, Bs, which is experimentally determined. Besides, the effect of chemical composition on the transformation kinetics are taken into consideration by using the theoretically calculated nucleation rate and growth rate.<BR>Excellent agreements are obtained between the calculated and experimental results for the effect of compositions (C, Mn, Si) on the transformation kinetics, the continuous cooling transformation diagrams and the microstructure after cooling.

収録刊行物

  • 鉄と鋼

    鉄と鋼 73 (8), 1026-1033, 1987

    一般社団法人 日本鉄鋼協会

被引用文献 (15)*注記

もっと見る

参考文献 (4)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ