単一および多段フラットスプレーノズルによる高温鉛直面の冷却特性

DOI Web Site Web Site 参考文献10件

書誌事項

タイトル別名
  • Heat Transfer Characteristics with Single and Multi-stage Flat Spray Nozzles on a Hot Vertical Surface Cooling
  • タンイツ オヨビ タダン フラット スプレー ノズル ニヨル コウオン エンチ

この論文をさがす

抄録

In order to improve water cooling technique for flanges in rolled H-shapes for the prevention of cooling buckling on thin web, an experimental study on a hot vertical surface cooling with single and multi-stage spray nozzles was carried out.<BR>First, the effects of nozzle pressure, nozzle angle and nozzle-plate distance on heat transfer coefficient of a hot vertical surface were investigated with a single spray nozzle. Next, with multi-stage spray nozzles the effect of flowing water from the upper area on heat transfer coefficients of the lower water strike zone and flowing water zone was investigated.<BR>The results obtained are summarized as follows.<BR>(1) The heat transfer coefficient of water strike zone with a single spray nozzle was described by water flux which is functions of nozzle pressure, nozzle angle and nozzle-plate distance.<BR>(2) In the case of high temperature with a single spray nozzle, the heat transfer coefficient ratio between flowing water zone and water strike zone is not affected by the cooling conditions, such as nozzle pressure, nozzle angle and nozzleplate distance.<BR>(3) However, in the case of low temperature, the ratio between flowing water zone and water strike zone on heat transfer coefficient strongly depends on the nozzle operating conditions.<BR>(4) On the other hand, in the case of multi-stage spray cooling, the existance of flowing water from the upper area enhances heat transfer coefficient of lower flowing zone. The maximum ratio of heat transfer coefficient between flowing water zone with water flowing down from above and without is from about 1.3 to 1.7.

収録刊行物

  • 鉄と鋼

    鉄と鋼 83 (4), 257-262, 1997

    一般社団法人 日本鉄鋼協会

参考文献 (10)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ