-
- IGUCHI Manabu
- Graduate School of Engineering, Hokkaido University
-
- CHIHARA Tomoyuki
- Daido Special Steel Co. Ltd.
-
- TSUJINO Ryoji
- Faculty of Engineering, Setsunan University
-
- SASAKI Yasushi
- Graduate School of Engineering, Tohoku University
-
- NISHIHARA Kazuyoshi
- Graduate School of Engineering, Osaka Electro-Communication University
-
- MATSUI Goichi
- School of BOST, Kinki University
この論文をさがす
抄録
Bubble formation from a centered single-hole nozzle placed on the bottom of a mercury bath has been investigated using an electroresistivity probe. The nozzle is made of brass and its surface is coated with fluororesin. Accordingly, the nozzle is poorly wetted by mercury. When the gas flow rate is lower than a certain critical value, the frequency of bubble formation is specified by the outer diameter of nozzle, dno. On the other hand, when the gas flow rate is raised above another critical value, the inner diameter of nozzle, dni, governs the bubble formation. Empirical equations are proposed for the two critical gas flow rates. Bubble formation is affected by dno and dni in the regime between the two critical gas flow rate values.
収録刊行物
-
- 実験力学
-
実験力学 8 (Special_Issue), s115-s119, 2008
日本実験力学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282680166833152
-
- NII論文ID
- 10021156153
-
- NII書誌ID
- AA11822914
-
- ISSN
- 18844219
- 13464930
-
- NDL書誌ID
- 9568233
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可