Development of Centrifugal Separator in New Cleaning System Using Sponge Balls for Heat Exchanger

DOI Web Site 被引用文献1件 参考文献3件
  • MONJI H.
    Department of Engineering Mechanics and Energy, Tsukuba University, Tsukuba 305-8573, Japan
  • SASAKI S.
    Department of Engineering Mechanics and Energy, Tsukuba University, Tsukuba 305-8573, Japan
  • NAKAJIMA M.
    E. P. Tech., Hitachi 317-0056, Japan
  • MIDORISAWA T.
    Hitachi Setsubi Engineering Co., LTD., Hitachi 317-0076, Japan

この論文をさがす

抄録

A device was proposed to separate sponge balls from water, used in the cleaning system of heat exchangers. This experimental study was conducted to investigate the operational behavior of the centrifugal separator, aiming at improving its efficiency. The circulation behavior of a single particle (simulating the sponge ball) in the rotating flow generated inside the transparent scale-down model of the centrifugal separator was examined. It was observed that the tendency of the particle moving away from the circulation center in radial direction became stronger with increasing flow rate. Furthermore, the separation efficiency was found to depend strongly on the ratio of the flow rate conveying particles to the inlet flow rate. This dependence became less significant with the increase of the inlet flow rate.

収録刊行物

  • 実験力学

    実験力学 7 (Special_Issue), s39-s43, 2007

    日本実験力学会

被引用文献 (1)*注記

もっと見る

参考文献 (3)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ