遠心鋳造方法によるアルミナ-ジルコニア複合セラミックス作製における微細組織不均一性

書誌事項

タイトル別名
  • Consolidation Induced Microstructural Inhomogeneities in Al2O3-ZrO2 Composites Prepared by Centrifugal Slip Casting

この論文をさがす

抄録

Centrifugal slip casting was applied to the fabrication of an Al2O3-5vol%ZrO2 (3Y-TZP) composite and the effect of solid contents in the slurry was investigated on various kinds of inhomogeneities and segregations. When a relatively thick slurry (40 or 45vol%) was used, mutually hindered settling occurred quite effectively and thus essentially no segregations were observed in the distribution of grain sizes and the dispersion of the two phases. Even the zirconia aggregates contained in the starting powders were found distributed over the entire body of a sample. On the other hand, when a slurry of moderate thickness (30vol%) was used, the Al2O3 and ZrO2 particles were still uniformly distributed but the zirconia aggregates were found accumulated in the thin layer of the bottom section. The results were discussed with a model calculation and shown to be in general agreement with the theoretical prediction.<br>

収録刊行物

参考文献 (37)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ